Page cover image

Normal Permanent Spoofing

Instructions for the standard permanent spoof.

MAKE SURE TO REMOVE ANY 'USB' ON YOUR PC CONNECTED, DISABLE TPM & SECUREBOOT

Jinx Permanent Spoofer Version 4

THESE STEPS TAKES 2 MINUTES AT MOST


  1. Launch the Loader

  • Open the loader.

  • Take a screenshot or photo of your current serials (Baseboard, BIOS, UUID, etc.).

  1. Start Spoofing

  • Go to the Spoofing tab.

  • Click Permanent Spoof. - Enable Insyde Mode if you're using an Insyde motherboard.

  • Choose your motherboard brand from the list.

  • Wait until the process is complete.

  1. Check Serials

  • Recheck your serials and make sure they’ve been changed from the originals.

  1. Go to the Misc Tab

  • Click Network Woof.

  • If you're on a laptop, highly recommended to run MAC Spoof.

  1. DISK Ban Bypass

  • Install Fortnite Or Your Game on a VHD drive. - (Skip this if you’ve already done a RAID reinstallation.)

EFI Spoof Method (If Serials Didn’t Change)

  1. Open the EFI Pre-Setup Loader and wait until a U: drive appears in File Explorer.

  2. Reopen the Spoofer Loader, click on EFI SPOOF, and enter the drive letter U.

  3. Go into your BIOS, and boot into the partition labeled "UEFI OS" or "UEFI Partition 1". (Always choose UEFI)

  4. After booting, check your serials again to confirm they’ve been spoofed successfully.

  5. You're fully spoofed.

SEND US YOUR OLD SERIALS BY A SCREENSHOT OF THE 'SERIAL CHECKER' TAB

Last updated

Was this helpful?